Getting Started
HW-130 Programmer User Guide 1-11
3. Verify that the drive was mounted correctly by typing:
/etc/mount
The displayed list of mounted devices should include the drive
you just mounted.
Running the CD-ROM Installation Script
The easiest way to install the software is to run the installation script
from the CD-ROM.
1. Type the CD-ROM installation command for your platform:
2. The CD-ROM installation script will un-tar a file ‘hw130’ located
in the /cdrom/<platform_dir> to the target directory or install_dir.
The script will also allow you to change the install_dir if you do
not agree with the displayed default directory. Follow the
instructions on the screen.
Note: If the install script fails to install the software, you may
manually un-tar the HW-130 software from the appropriate sub-
directory to the install_dir. Create an install_dir target directory and
change directory (cd) to it.
mkdir <install_dir>
cd <install_dir>
Sun OS: /cdrom/install
Solaris: /cdrom/install
Note: Vold (Volume Management Deamon) might
have mounted the CD-ROM to ‘/cdrom/hw130’ or
‘/cdrom/cdrom0’ in which case you should run
‘/cdrom/hw130/install’ or
‘/cdrom/cdrom0/install’
HP: /cdrom/install
IBM: /cdrom/install.rs6
To Next Page