Xilinx HW-130 - Page 85

HW-130 Programmer User Guide i
Index
A
adapter
calibration adapter, B-1
socket adapter, 1-5
appending data, 2-12
auto-calibration, B-1
autohandler mode
programmer oeprations, C-2
setup instructions, C-1
automating programmer operations, C-1
B
baud rate, 1-15
buttons. See commands
C
calculating device checksum, 2-10
calibration adapter, B-1
checking for blank device, 2-9
command selection
keyboard, 1-17, A-1
mouse, 1-17
commands
see also programmer procedures
About HW-130 (Help menu), 3-3
alphabetical list, 3-3
Append Data (File menu), 3-3
Auto-Calibration (Options menu), 3-3
Autohandler Mode (Options menu) 3-4
Blank Check Device (Options menu) 3-4
Communications (Options menu), 3-4
Contents (Help menu), 3-5
Device Checksum (Options menu), 3-5
Diagnostics (Options menu), 3-6
Exit (File menu), 3-7
Load Master Device (Options menu) 3-7
Open File (File menu), 3-8
Profile (File menu), 3-8
Program Device (Options menu), 3-8
Reset Programmer, 1-6
Reset Programmer (Options menu), 3-9
Save RAM to File (File menu), 3-9
Save Settings, 1-16
Save Settings (File menu), 3-9
Select Device (File menu), 3-10
Signature String (Options menu), 3-10
Sound (Options menu), 3-10
Verify Device (Options menu), 3-10
Communications dialog box, 1-16
communications port, 1-15
configuration
software, 1-15
D
design selection, 2-3
Device Secured field, 2-7
Device Selection dialog box, 2-3
device specification, 2-2
diagnostics
calibration adapter, B-1
measuring voltage and current, B-2
memory test, B-5
pin driver clock test, B-5
procedures, B-1
programmable supply voltage, B-5
programmer blocks, B-3
RS-232 communications test, B-4
Diagnostics dialog box, B-4