SonTek RS5 User Manual (August 2020) 122
Figure 113. Extract Subsection Dialog
The dialog requires the user to define new left and right bank edges, which are shown
visually with grey areas. The edge definition is required in order to perform proper
discharge calculations on the subsectioned data. The example shown in Figure 114
depicts a subsectioned region that will have:
Left edge between samples 40 and 50
Transect between samples 51 and 94
Right edge between samples 95 and 105
Clicking OK will create a new transect that will appear at the end of the transect list in
the current measurement session with new parameters calculated, including final
discharge.
To Next Page
Loading...
