SonTek RS5 User Manual (August 2020) 96
Figure 78. Recorded Data Tab
7.11. Discharge Summary Overview
While collecting multiple transects, it is often useful to show the Discharge Summary,
described in Section 6.5.9. By using [CTRL+S] or activating the Discharge Summary
through the Window button (main toolbar), the user can compare discharge and many
other related parameters among already-collected transects. An example of the
Discharge Summary is shown in Figure 79.
Figure 79. Discharge Summ ary
Each line in the Discharge Summary represents one transect. During an active
measurement session, the user can first click on the Recorded Data tab (see Figure
78), and then any subsequent clicks on an individual line in the Discharge Summary will
activate that specific transect for viewing.
The area highlighted in Figure 78 shows parameters that always appear in every
Discharge Summary. From left to right, the columns indicate:
Check box – select this box to use this transect in the statistics at the bottom. De-
selecting this for a transect removes it from the statistics calculations.
Type of Measurement – indicates whether the transect is a Loop [ ], SMBA
[ ], or Transect [ ]
To Next Page
Loading...
