Yaesu FT-710 User Manual

26
• MARKER
Displays markers that indicates the position of the
current receive and the transmit frequencies in the
spectrum.
Press the [FUNC] knob then touch [MARKER] to
turn the MARKER ON or OFF. Normally leave it
ON.
Receive Frequency Transmit Frequency
• COLOR
The display color of the scope screen can be
changed.
Press the [FUNC] knob then touch [COLOR], then
touch the desired color from the color selection
screen.
The Display Color selection screen will disappear
automatically after about 5 seconds.
• Adjust contrast
Adjust the contrast of the TFT display.
Press the [FUNC] knob then touch [CONTRAST],
and then turn the [FUNC] knob to adjust the con-
trast.
• Adjusting the brightness (DIMMER)
Adjust the brightness of the TFT display.
Press the [FUNC] knob then touch [DIMMER], and
then turn the [FUNC] knob to adjust the brightness.

Yaesu FT-710 Specifications

General

Antenna Tuner	Built-in Automatic Antenna Tuner
Weight	4.5 kg
Type	HF/50 MHz Transceiver
Supply Voltage	13.8 V DC ±15%
IF Frequency	24 kHz
Antenna Connector	SO-239
TX Frequency Range	1.8 - 54 MHz
Modes	AM, FM
RF Output Power	100 Watts
Receiver Type	Superheterodyne
Display	4.3-inch Color TFT
Circuit Type	SDR (Software Defined Radio)
Current Consumption	22 A (maximum)
Output Power	5 - 100 Watts (adjustable)
Dimensions	239 x 80 x 247 mm (W x H x D)