Yamaha FT60D - Page 299

6C13G11
i-3
1
2
3
4
5
6
7
8
9
Index
E.
ECM (Electric Control Module) .................1-10
Electrical ........................................... 2-9
,
2-15
Electrical components.................................8-3
Electronic control system ............................1-9
Exhaust cover ...........................................5-35
F.
Features and benefits .................................1-7
Fire prevention ............................................1-3
Fuel and blowby hoses ...............................4-2
Fuel control system...................................8-13
Fuel filter and fuel pump .............................4-4
Fuel system......................................... 1-7
,
3-3
G.
Gear pump ................................................7-35
General .....................................................3-16
General specifications.................................2-1
General torques ........................................2-24
Good working practices ..............................1-4
H.
Hose routing................................................4-2
How to use this manual...............................1-1
I.
Identification................................................1-4
Ignition and ignition control system.............8-8
Installing the camshaft ..............................5-32
Installing the clamp brackets.....................7-27
Installing the cylinder head .......................5-34
Installing the lower unit ................... 6-19
,
6-44
Installing the oil pump ...............................5-33
Installing the oil seal housing ....................6-18
Installing the pinion ......................... 6-17
,
6-42
Installing the power trim
and tilt unit/hydro unit..............................7-47
Installing the power unit ............................5-49
Installing the propeller
shaft housing................................. 6-18
,
6-42
Installing the rocker arm shaft assembly...5-32
Installing the steering arm.........................7-23
Installing the throttle position sensor.........4-11
Installing the timing belt and sprockets .....5-17
Installing the upper case ...........................7-21
Installing the valves...................................5-31
Installing the water pump ..........................6-19
Installing the water pump and shift rod .....6-43
Intake manifold............................................4-8
Introduction .................................................9-2
L.
Lower unit ................................ 2-8
,
2-14
,
3-14
Lower unit (F50, F60) ................................. 6-5
Lower unit (FT50, FT60)........................... 6-28
Lubricating the outboard motor................. 3-18
Lubricating the tiller handle bracket............ 7-8
M.
Maintenance interval chart ......................... 3-2
Maintenance specification .......................... 2-5
Manual format............................................. 1-1
Measuring the forward
and reverse gear backlash ..................... 6-25
Measuring the forward gear backlash ...... 6-50
Measuring the fuel pressure ..................... 4-16
Measuring the lower resistance.................. 8-2
Measuring the peak voltage ....................... 8-2
O.
Outline of features ...................................... 1-6
P.
Parts, lubricants, and sealants ................... 1-3
Port view..................................................... 8-3
Power trim and tilt electrical system ......... 7-49
Power trim and tilt motor........................... 7-31
Power trim and tilt unit .....................7-29
,
9-22
Power unit...................2-5
,
2-11
,
3-3
,
5-3
,
9-7
Predelivery checks ................................... 1-13
Propeller selection .................................... 1-12
Propeller shaft housing (F50, F60) ............. 6-8
Propeller shaft housing (FT50, FT60)....... 6-33
Propeller size............................................ 1-12
R.
Refacing the valve seat ............................ 5-27
Removing the clamp brackets .................. 7-27
Removing the cylinder head ..................... 5-23
Removing the drive shaft.................6-14
,
6-39
Removing the lower unit ....................6-7
,
6-31
Removing the power trim
and tilt unit/hydro tilt unit......................... 7-30
Removing the power unit.......................... 5-14
Removing the propeller shaft
housing assembly............................6-9
,
6-34
Removing the steering arm ...................... 7-23
Removing the timing belt
and sprockets ......................................... 5-15
Removing the upper case......................... 7-18
Removing the water pump.......................... 6-7