Yamaha RX-A3000 User Manual

CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En 45
7
Press iCursor B / C repeatedly to select
the “Measure” and press iENTER to start
measurement.
Auto measurement starts in 10 seconds.
Display during measurement
■ When “Multi Position” is set to “No” in
step 5
The calculation based on result of measurement starts
when measurement finishes without any problem.
When “Angle” is set to “No” in step 6
The following display appears when the calculation
finishes without any problems.
Go to step 14.
When “Angle” is set to “Yes” in step 6
The following display appears when the calculation
finishes without any problems.
Go to step 9.
■ When “Multi Position” is set to “Yes” in
step 5
The following display appears when measurement at the
first position finishes without any problems.
Go to step 8.
RETURN
ENTER
RETURN
ENTER
SOU
R
C
E
R
ECEIVE
R
AV
AU
DI
O
4
3
1
2
7
5
6
V
-A
UX
4
3
1
2
US
B
MU
LTI
N
ET
P
H
O
N
O
TUNER
D
OC
K
S
IRI
US
[
A
]
i
• To start the measurement immediately, press
iENTER again.
• To cancel the automatic setup, press
iRETURN and
then
iENTER.
NOTE
If a problem occurs, an error message or report is
displayed either during or after acoustic measurement.
Refer to “When an error message is displayed during
measurement” (☞
p. 49), or “When a warning
message is displayed after measurement” (☞
p. 50) to
resolve the problem and measure acoustics with
YPAO again.


Progress0%
Measuring...
YPAO
VOLUME


Save/Exit
Measure.Finish
YPAO
VOLUME


>YesNo
AngleMeasure?
YPAO
VOLUME


>YesNo
MLT.Position2?
YPAO
VOLUME
Continues to the
next page

Yamaha RX-A3000 Specifications

General

Brand	Yamaha
Model	RX-A3000
Category	Receiver
Language	English