Yamaha XF50W - Page 80

CHANGING THE ENGINE OIL
CHK
ADJ
<&
EAS00076
CHANGING THE ENGINE OIL
1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
8engine oil filler cap 1
8engine oil drain bolt 2
(along with the gasket)
4. Drain:
8engine oil
(completely from the crankcase)
5. If the oil filter element is also to be replaced
or cleaned, perform the following procedure.
•••••••••••••••••••••••
a. Remove the oil strainer cover 1,spring3
and oil filter element 4.
b. Replace the O-ring New 2
c. Install the new or clean oil filter element and
the oil strainer cover.
Oil strainer cover
32Nm(3.2m • kg, 23.1ft • lb)
•••••••••••••••••••••••
6. Install:
• engine oil drain bolt
(along with the gasket)
X| 23Nm(2.3m * kg, 16.6ft * lb)
7. Fill:
• crankcase
(with the specified amount of the recom-
mended engine oil)
«0
Quantity
Total amount
0.8~0.9L(0.74~0.83 Imp qt, 0.87~0.98
US qt)
Periodic oil change
0.73~0.83L(0.67~0.76 Imp qt,
0.80~0.90 US qt)
3-25
Downloaded from www.ScooterTime.net