3.2 Operating Procedures for Utility Functions
3.2.15 Write Prohibition Setting (Fn010)
3-39
Preparations
No preparations are required.
Fn01B Initialize Vibration Detection Level Cannot be executed.
Fn01E Display SERVOPACK and Servomotor IDs Can be executed.
Fn01F
Display Servomotor ID from Feedback Option
Module
Can be executed.
Fn020 Set Absolute Linear Encoder Origin Cannot be executed.
Fn030 Software Reset Can be executed.
Fn080 Polarity Detection Cannot be executed.
Fn200 Tuning-less Level Setting Cannot be executed.
Fn201 Advanced Autotuning without Reference Cannot be executed.
Fn202 Advanced Autotuning with Reference Cannot be executed.
Fn203 One-Parameter Tuning Cannot be executed.
Fn204 Adjust Anti-resonance Control Cannot be executed.
Fn205 Vibration Suppression Cannot be executed.
Fn206 Easy FFT Cannot be executed.
FnB03
Edit/Save Program Table Cannot be executed.
FnB04
Edit/Save ZONE Table Cannot be executed.
FnB05
Edit/Save Jog Speed Table Cannot be executed.
FnB06
Initialize Program Table Cannot be executed.
FnB07
Initialize ZONE Table Cannot be executed.
FnB08
Initialize Jog Speed Table Cannot be executed.
FnB09
Set Absolute Encoder Origin Cannot be executed.
FnB0A
INDEXER Status Monitor Can be executed.
FnB0B
Initialize INDEXER Parameter Settings Cannot be executed.
FnB0C
Reset INDEXER Alarm Cannot be executed.
FnB0D
Display INDEXER Alarm History Can be executed.
Continued from previous page.
Fn No. Function
When Writing Is Pro-
hibited
To Next Page
Loading...
