EasyManua.ls Logo

YASKAWA E-7 Series - Page 159

YASKAWA E-7 Series
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3.2 Operating Procedures for Utility Functions
3.2.31 Adjust Anti-resonance Control (Fn204)
3-97
3
Utility Functions
5
Use the Key or Key to
move the cursor and the Key
or Key to adjust the fre-
quency.
6
Press the Key.
The cursor will move to damp.
7
Use the Key or Key to
move the cursor and the Key
or Key to adjust the damping
gain.
Note: Increase the damping gain by
approximately 0% to 200% in 10%
increments while checking the
effect on vibration. If vibration
reduction is still insufficient at a
gain of 200%, cancel the setting,
and lower the control gain by using
a different method, such as one-
parameter tuning.
8
If fine-tuning of the frequency is
necessary, press the Key. The
cursor will move from damp to
freq. Go to step 9.
If fine-tuning is not required, go to
step 10.
Continued on next page.
Continued from previous page.
Step Operation Result
1:RUN Vib S up
f r e q = 0 1 0 0 Hz
d a m p =0000
1:RUN Vib S up
f r e q = 0 4 0 0 Hz
d a m p =0000
1:RUN Vib S up
f r e q = 0 4 0 0 Hz
d a m p =0020
Measured Waveform Example
Deviation
Torque reference
Positioning Completion signal
1:RUN Vib S up
f r e q = 0 4 0 0 Hz
d a m p =0120

Table of Contents

Related product manuals