YASKAWA FSDrive-MV1000 Series - Page 206

6.6 Replacing Power Cells
206 YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions
n Mounting
1. Mount a Power Cell by following the procedure for removal in reverse.
2. Move the Power Cell that is loaded on a lifter to the front of the drive panel in which the Power Cell is to be
inserted.
3. Push the Power Cell in from the front and mount it.
Figure 6.11
Figure 6.8 Inserting a Power Cell
4. Connect the three-phase input wiring to the input terminals (L1, L2, L3), and connect the wiring to the output
terminals (T1, T2).
5. Connect the fiber optic cable to the cell control board (CCB).
Figure 6. 12
Figure 6. 13
Figure 6.9 Wiring of Power Cells
A – Drive C – Lifter
B – Power Cells D – Fix the lifter at the
appropriate height for the
Power Cell.
A – Fiber optic cable C – Input terminals
(L1, L2, L3)
B – Output terminals
(T1, T2)
C
D
A
E
F
B
C
D
A
B
＜
Power Cell Placed Horizontally
＞＜
Power Cell Placed Vertically
＞
Asia
C
A
B
C
A
B
＜
Power Cell Placed Horizontally
＞＜
Power Cell Placed Vertically
＞
Asia