2.10 o: Operator Related Settings
YASKAWA ELECTRIC TOEP C710687 03B FSDrive-MV1000 Parameter Guide 237
n o4-12: kWh Monitor Initialization
The kWh monitors U4-10 and U4-11 are not initialized when the power is shut off or the drive is initialized. Use o4-12 to
manually reset them.
Setting 0: No Action
The kWh data are kept as they are.
Setting 1: Reset kWh Data
Resets the kWh counter. The monitors U4-10 and U4-11 will display “0” after they are initialized. When o4-12 is set to 1
and the ENTER key is pressed, kWh data is erased and the display returns to 0.
n
o4-13: Number of Run Commands Counter Initialization
The Run command counter displayed in U4-02 is not reset when the power is cycled or the drive is initialized. Use o4-13
to reset U4-02.
Setting 0: No Action
The Run command data are kept.
Setting 1: Number of Run Commands Counter
Resets the Run command counter. The monitor U4-02 will show 0. When o4-13 is set to 1 and the ENTER key is
pressed, the counter value is erased and the setting of the parameter returns to 0.
n
o4-20: Event Log Initialization
Sets the method for initializing event log data.
Setting 0: Event log data is retained.
Setting 1: Event log data is initialized (setting returned to 0 after initialization).
n o4-21: Trace Initialization
Sets the method for initializing trace data.
Setting 0: Trace data is retained.
Setting 1: Trace data is initialized (setting returned to 0 after initialization).
u T: Motor Tuning
Auto-Tuning automatically sets and tunes parameters required for optimal motor performance.
For details, refer to the FSDrive-MV1000 Instructions (Manual No. TOEP C710687 02).
No. Name Setting Range Default
o4-12 kWh Monitor Initialization 0, 1 0
No. Name Setting Range Default
o4-13
Number of Run Commands Counter
Initialization
0, 1 0
No. Name Setting Range Default
o4-20 Event Log Initialization 0, 1 0
No. Name Setting Range Default
o4-21 Trace Initialization 0, 1 0
MV1000ParameterGuide_E_conditional.book 237 ページ ２０１３年１０月１１日 金曜日 午後８時１８分
To Next Page
Loading...
