2.11 U: Monitor Parameters
YASKAWA ELECTRIC TOEP C710687 03B FSDrive-MV1000 Parameter Guide 239
u U6: Control Monitors
Control monitors show:
• Reference data for the output voltage and vector control
• ASR and Feed Forward control monitors
• Pulse data from the PG motor encoder
• ASR and Feed Forward control monitors
• ASR and Feed Forward control monitors Refer to Figure 2.27 on page 136 and Figure 2.28 on page 137 for details
and an illustration showing where monitors are located in the ASR block.
• The offset value added to the frequency reference by the frequency offset function. Refer to Setting 44, 45, 46: Offset
Frequency 1, 2, 3 on page 178.
• The bias value added to the frequency reference by the Up/Down 2 function (refer to Setting 75, 76: Up 2, Down 2
Command on page 179)
Refer to U6: Control Monitors on page 82 for a complete list of U6- monitors and descriptions.
u U9: Power Cell Monitor
Power cell monitors show:
• Status of each power cell
• DC bus voltage of each power cell
• Temperature of each power cell
• Output current of each power cell
• Software No. of each power cell
Refer to U9: Power Cell Monitors on page 83 for a complete list of U9- monitors and descriptions.
MV1000ParameterGuide_E_conditional.book 239 ページ ２０１３年１０月１１日 金曜日 午後８時１８分
To Next Page
Loading...
