1.3 Parameter Table
76 YASKAWA ELECTRIC TOEP C710687 03B FSDrive-MV1000 Parameter Guide
u U: Monitors
Monitor parameters allow the user to view drive status, fault information, and other data concerning drive operation.
No.
(Addr.)
Name Description
Analog Output
Level
Unit Page
U1: Operation Status Monitors
U1-01
(40H)
Frequency
Reference
Monitors the frequency reference. Display units are determined by o1-03.
10 V: Max
frequency
0.01 Hz –
U1-02
(41H)
Output
Frequency
Displays the output frequency. Display units are determined by o1-03.
10 V: Max
frequency
0.01 Hz –
U1-03
(42H)
Output Current
Displays the output current.
10 V: Drive
rated current
0.1 A –
U1-04
(43H)
Control Method
0: V/f Control
2: Open Loop Vector Control
3: Closed Loop Vector Control
No signal output
available
––
U1-05
(44H)
Motor Speed
Displays the motor speed feedback.
Display units are determined by o1-03.
10 V: Max
frequency
0.01 Hz –
U1-06
(45H)
Output Voltage
Reference
Displays the output voltage.
10 V: Drive
rated voltage
1 V –
U1-07
(46H)
DC Bus Voltage
Displays the average DC bus voltage of each Power Cell.
10 V: 2000 V 1 V –
U1-08
(47H)
Output Power
Displays the output power (this value is calculated internally).
10 V: Drive
capacity (motor
rated capacity)
kW
<60>
1 kW –
U1-09
(48H)
Torque
Reference
Monitors the internal torque reference.
10 V: Motor
rated torque
0.1% –
U1-10
(49H)
Input Terminal
Status
Displays the input terminal status.
No signal output
available
––
U1-11
(4AH)
Output Terminal
Status
Displays the output terminal status
No signal output
available
––
CLV
V/f
OLV
U1
-
10=
00000000
1: ON 0: OFF
Contact Input 2
Contact Input 3
Contact Input 4
Contact Input 5
Contact Input 6
Contact Input 7
Contact Input 8
U1
-
11=
00000000
1: ON 0: OFF
Contact Output 1
Contact Output 2
Contact Output 3
Contact Output 4
Contact Output 5
Contact Output 6
Contact Output 7
Contact Output 8
MV1000ParameterGuide_E_conditional.book 76 ページ ２０１３年１０月１１日 金曜日 午後８時１８分
To Next Page
Loading...
