YASKAWA FSDrive-MV1000 - Start-Up Programming & Operation

1.3 Parameter Table
YASKAWA ELECTRIC TOEP C710687 03B FSDrive-MV1000 Parameter Guide 77
U1-12
(4BH)
Drive Status
Verifies the drive operation status.
No signal output
available
––
U1-13
(4EH)
Analog Input 1
Input Voltage
Displays the voltage of analog input 1.
10 V: 100% 0.1% –
U1-14
(4FH)
Analog Input 2
Input Voltage
Displays the input voltage of analog input 2.
10 V: 100% 0.1% –
U1-16
(53H)
Output
Frequency after
Soft Starter
Displays output frequency with ramp time and S-curves. Units determined
by o1-03.
10 V: Max
frequency
0.01 Hz –
U1-17
(58H)
DI-A3 Input
Status
Displays the reference value input from the DI-A3 option card.
Display will appear in hexadecimal as determined by the digital card input
selection in F3-01.
3FFFF: Set (1 bit) + sign (1 bit) + 16 bits
No signal output
available
––
U1-18
(61H)
oPE Fault
Parameter
Displays the parameter number that caused the oPE or Err (EEPROM
write error) error.
No signal output
available
––
U1-19
(66H)
MEMOBUS/
Modbus Error
Code
Displays the contents of a MEMOBUS/Modbus error.
No signal output
available
––
U1-21
(77H)
AI-A3 Terminal
V1 Input Voltage
Monitor
Displays the input voltage to terminal V1 on analog input card AI-A3.
10 V: 100% 0.1% –
U1-22
(72AH)
AI-A3 Terminal
V2 Input Voltage
Monitor
Displays the input voltage to terminal V2 on analog input card AI-A3.
10 V: 100% 0.1% –
U1-23
(72BH)
AI-A3 Terminal
V3 Input Voltage
Monitor
Displays the input voltage to terminal V3 on analog input card AI-A3.
10 V: 100% 0.1% –
U1-25
(4DH)
Software
Number (Flash)
Displays FLASH ID.
No signal output
available
––
U1-26
(5BH)
Software No.
(ROM)
Displays ROM ID.
No signal output
available
––
No.
(Addr.)
Name Description
Analog Output
Level
Unit Page
All Modes
common_
U1 - 12=
00000000
During run
During zero-speed
During REV
During fault reset
signal input
During speed agree
During ready
During alarm detection
During fault detection
1: ON 0: OFF
All Modes
common_
All Modes
common_
All Modes
common_
All Modes
common_
All Modes
common_
All Modes
common_
CRC Error
Data Length Error
Not used
(always OFF)
Parity Error
Overrun Error
Framing error
Time Out
Not used
(always OFF)
1: ON 0: OFF
U1 - 19=
00000000
All Modes
common_
All Modes
common_
All Modes
common_
All Modes
common_
All Modes
common_
MV1000ParameterGuide_E_conditional.book 77 ページ ２０１３年１０月１１日 金曜日 午後８時１８分