148 YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions
5.9 Copy Function Related Displays
5.9 Copy Function Related Displays
◆ Tasks, Errors, and Troubleshooting
The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the digital operator indicates the task being performed. When an
error occurs, a code appears on the digital operator to indicate the error. Note that errors related to the Copy function do
not trigger a sequence terminal set for fault or alarm output. To clear an error, simply press any key on the LCD operator.
Refer to Table 5.18 to take proper measures and remove the cause.
Note: 1. Whenever using the copy function, the drive should be fully stopped.
2. The drive will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to an drive when the voltage class, capacity, control mode, and software version match.
Table 5.18 Copy Function Task and Error Displays
Digital Operator Display Error Name
CoPy Writing Parameter Settings (flashing)
Cause Possible Solution
Parameters are being written to the drive. Not an error.
Digital Operator Display Error Name
CPEr
Control Mode Mismatch
Cause Possible Solution
Control mode of the parameters to be loaded
onto the drive and the control mode already
set to the drive don’t match.
Check the control mode for the parameters that are to be loaded onto the drive and the
control mode set to the drive those parameters will be written to.
⇒Set the same control mode using parameter A1-02 and try again.
Digital Operator Display Error Name
CPyE Error Writing Data
Cause Possible Solution
Failed writing parameters. ⇒Try writing parameters again.
Digital Operator Display Error Name
CSEr Copy Unit Error
Cause Possible Solution
Hardware fault ⇒Replace the digital operator or the USB Copy Unit.
Digital Operator Display Error Name
dFPS Drive Model Mismatch
Cause Possible Solution
The drive from which the parameter were
copied and the drive you are attempting to
write to are not the same model.
• The drive the parameters were copied from
is a different model drive.
• The drive you are attempting to write to is a
different model.
Check the model number of the drive that the parameters were copied from and the model
of the drive you are attempting to write those parameters to.
⇒Make sure the drive from which the parameter are copied and the drive to be written to
have the same model numbers and software versions.
Digital Operator Display Error Name
End Task Complete
Cause Possible Solution
Finished reading, writing, or verifying
parameters.
Not an error.
Digital Operator Display Error Name
iFEr Communication Error
Cause Possible Solution
A communication error occurred between the
drive and the digital operator or the USB
Copy Unit.
⇒Check the cable connection.
A non-compatible cable is being used to
connect the USB Copy Unit and the drive.
⇒Use the cable originally packaged with the USB Copy Unit.
To Next Page
Loading...
