4.3 The Drive and Programming Modes
88 YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions
◆ Switching between LOCAL and REMOTE
When the drive is set to accept the Run command from the digital operator RUN key, this is referred to as LOCAL mode.
When the drive is set to accept the Run command from an external device (via the input terminals, serial
communications, etc.) this is referred to as REMOTE mode.
WARNING! Sudden Movement Hazard. The drive may start unexpectedly if the Run command is already applied when switching
from LOCAL mode to REMOTE mode when b1-07 = 1, resulting in death or serious injury. Be sure all personnel are
clear of rotating machinery.
The operation can be switched between LOCAL and REMOTE either by using the key on the digital operator or a digital input.
Note: 1. After selecting LOCAL, the LO/RE light will remain lit.
2. The drive will not allow the user to switch between LOCAL and REMOTE during run.
■ Using the LO/RE Key on the Digital Operator
■ Using Sequence Input Terminals 1 to 16 to Switch between LOCAL and REMOTE
The user can also switch between LOCAL and REMOTE modes using one of the sequence input terminals H1-01 to H1-
16 (set the corresponding parameter H1- to “1”).
The following section describes the procedure for configuring the sequence input terminals.
Note: Setting H1- to 1 disables the LO/RE key on the digital operator.
Operating Procedure LCD Display
1 Turn on the power to the drive. The initial display appears.
2
Press . The LO/RE light will light up.
To set the drive for REMOTE operation, press the key again. The LO/RE light will turn
on.
- MODE -
U1-01= 0.00Hz
U1-02= 0.00Hz
U1-03= 0.0A
DRV
FREF(OPR)
Rdy
JOG FWD FWD/REV
LSEQ
LREF
RE
LO
LO
RE
F2F1
ESC
RUN STOP
ENTERRESET
ALM
DIGITAL OPERATOR JVOP-180
- MODE -
U1-01= 0.00Hz
U1-02= 0.00Hz
U1-03= 0.00A
DRV
䉲䊠䉡䊊䉴䉡䉲䊧䉟㩿OPR㪀
Rdy
JOG FWD FWD/REV
LSEQ
LREF
Off
Lit
To Next Page
Loading...
