YASKAWA FSDrive-MV1000 - Setup Group Parameters

4.3 The Drive and Programming Modes
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions 89
Start-Up Programming & Operation
4
◆ Setup Group Parameters
■ Setup Group (STUP)
Parameters used in this drive are categorized into A to U. In order to simplify the drive’s setup, only the frequently used
parameters are selected into the setup mode.
1.
Display the “Setup Group” screen first. Press the or key until the “Setup Group” screen is displayed.
2. Select a parameter, and change the setting. Table 4.5 shows the parameters that can be used in the Setup
Group. If a parameter to set is not found in the Setup Group, use the “Parameter Setting Mode” screen.
Note: 1. When the parameter “A1-02” (Control Method Selection) is changed, the setting values of some parameters are changed
automatically.
2. This manual explains also the parameters that are not displayed in the setup mode. Use the “Par” menu in the program mode when
setting a parameter that is not displayed in the setup mode.
Table 4.5 Setup Group Parameters
No. Name No. Name
A1-02 Control Method Selection E1-05 Maximum Voltage
A1-06 Application Preset E1-06 Base Frequency
b1-01 Frequency Reference Selection 1 E1-09 Minimum Output Frequency
b1-02 Run Command Selection 1 E1-13 Base Voltage
b1-03 Stopping Method Selection E2-01 Motor Rated Current
C1-01 Acceleration Time 1 E2-04 Number of Motor Poles
C1-02 Deceleration Time 1 E2-11 Motor Rated Power
d1-01 Frequency Reference 1 H4-02 Analog Output 1 Gain
d1-02 Frequency Reference 2 H4-12 Analog Output 2 Gain
d1-03 Frequency Reference 3 H4-22 Analog Output 3 Gain
d1-04 Frequency Reference 4 H4-32 Analog Output 4 Gain
d1-17 Jog Frequency Reference L1-01 Motor Overload Protection Selection
E1-01 Input Voltage Setting L3-04 Stall Prevention Selection during Deceleration
E1-04 Maximum Output Frequency