YASKAWA FSDrive-MV1000 - Transporting

2.2 Mechanical Installation
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions 37
Mechanical Installation
2
◆ Transporting
The method of transport differs depending on the model of drive.
Transport the drive by using the appropriate method indicated in the table below.
Table 2.3 Models and Transportation Methods
When using rollers to move the drive panel, make sure that the following conditions are met. Improper handling could
result in damage to the drive.
• Place the panel on the rollers while adjusting their positions so that they extend approximately 100 mm each side of the
panel’s frame.
• Distribute the weight of the drive evenly on the rollers so stress is evenly distributed on the bottom of the drive.
• Create a smooth, even surface for rolling by laying boards flat on the floor. Use boards with sufficient strength and
durability, and make sure the boards do not have gaps between them.
Voltage
Class
(kV)
Motor Power
(HP)
Transportation Method
2
200 to 600
Use the support hooks on the top of the drive to lift the drive.
For details on the transportation procedure, refer to Table 2.4.
700 to 1750
<1>
Use the support hooks to lift the transformer panel.
For details on the transportation procedure, refer to Table 2.5.
Use the support hooks on the top of the drive to lift the Power Cell and control panels.
For details on the transportation procedure, refer to Table 2.4.
2000 to 2750
<1>
Use the support hooks to lift the transformer panel.
For details on the transportation procedure, refer to Table 2.5.
Use the support hooks on the top of the drive to lift the Power Cell and control panels.
For details on the transportation procedure, refer to Table 2.4.
4
400 to 1000
<1> The following models are under development.
2-kV class: 700 to 1750 HP, 2000 to 2750 HP
4-kV class: 1750 to 3000 HP, 3500 to 5000 HP
Use the support hooks on the top of the drive to lift the drive.
For details on the transportation procedure, refer to Table 2.6.
1250 to 3000
<1>
Use the support hooks to lift the transformer panel.
For details on the transportation procedure, refer to Table 2.7.
Use the support hooks on the top of the drive to lift the Power Cell and control panels.
For details on the transportation procedure, refer to Table 2.6.
3500 to 5000
<1>
Use the support hooks to lift the transformer panel.
For details on the transportation procedure, refer to Table 2.7.
Use the support hooks on the top of the drive to lift the Power Cell and control panels.
For details on the transportation procedure, refer to Table 2.6.