YASKAWA FSDrive-MV1000 - The Drive and Programming Modes

4.3 The Drive and Programming Modes
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions 83
Start-Up Programming & Operation
4
4.3 The Drive and Programming Modes
The drive has a Programming Mode to program the drive for operation, and a Drive Mode used to actually run the motor.
Drive Mode: In the Drive Mode, the user can start the motor and observe operation status with the monitors that are
available. Parameter settings cannot be edited or changed when in the Drive Mode.
Programming Mode: The Programming Mode allows access to edit, adjust, and verify parameters, as well as perform
Auto-Tuning. Unless set to allow a Run command, the drive will not accept a Run command when the digital operator is
in the Programming Mode.
Table 4.4 describes the functions accessible by pressing the ⋅ keys of the digital operator.
Note: To allow the drive to run the motor while in the Programming Mode, set b1-08 to 1.
Table 4.4 Modes
Mode Contents Key LCD Display
Drive Mode
(Operation/operation status
monitor of the motor)
Frequency Reference
x
Monitor Display
x
Programming Mode
(Parameter setting)
Verify Menu
x
Setup Group
x
Parameter Setting Mode
x
Auto-Tuning Mode
x
- MODE -
U1-01= 0.00Hz
U1-02= 0.00Hz
U1-03= 0.0A
DRV
FREF(OPR)
Rdy
JOG FWD FWD/REV
LSEQ
LREF
- MODE -
U1-01= 0.00Hz
U1-02= 0.00Hz
U1-03= 0.0A
DRV
Monitor Menu
Rdy
JOG FWD FWD/REV
LSEQ
LREF
- MODE - PRG
Modified Consts
HELP DATA
FWD
Modified
X Parameters
HELP
- MODE - PRG
Quick Setting
DATA
FWD
HELP
- MODE - PRG
DATA
Programming
FWD
HELP
- MODE - PRG
Auto-Tuning
DATA
AUTO
FWD