2.4 Storing Drives
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions 51
Figure 2.19
Figure 2.19 Preparing a Drive for Storage
■ Other Precautions
Devise measures to prevent the in-panel wiring and cables being damaged by rats or other possible causes.
■
Periodic Inspection
Inspect the following points every month.
• The color of the silica gel has changed, indicating that moisture was absorbed.
(Use the type of silica gel that changes color and check absorbency based on the degree of color change.)
• The drive is not wet due to humidity or roof leaks.
• The drive is neither corroded nor rusted (both the interior and exterior).
NOTICE: Before turning on the power to the drive after a long period in storage, carefully check for moisture and dust.
Failure to comply could result in damage by fire or other damage.
Sheet (Use two layers of sheeting at least 0.1 mm thick.)
Front of drive
Drive side face
Square
timbers
Shock-absorbing material
Floor
50 to 100 mm
Square
timbers
Shock-absorbing material
To Next Page
Loading...
