Mechanical Installation
2
2.6 Install the Keypad in a Control Panel or Another Device
YASKAWA SIEPC71061737B GA800 Drive Technical Reference 41
Table 2.2 Exterior Dimensions (mm)
W H D D1 D2 R
*1
W1 W2 H1 d
65 106 16 8.2 1.6 53.8 44 15 78 M3
*1 Minimum bending radius
■ Mount to the Outside of Control Panel
1. Use the panel cut-out dimensions in Figure 2.11 and Table 2.3 to cut an opening in the control panel for the
keypad.
Figure 2.11 Panel Cut-Out Dimensions to Attach Outside of Control Panel
Table 2.3 Panel Cut-out Dimensions mm (in)
W H W1 H1 H2 H3 d
22 (0.89) 78 (3.07) 22 (0.89) 29 (1.14) 22 (0.89) 1 (0.04) 3.6 (0.14)
2. Remove the keypad and put the keypad connector in the holder on the front cover.
Note:
Insert the end of the keypad connector that has the tab.
A - Keypad
B - Keypad connector
C - Holder
Figure 2.12 Remove the Keypad
3. Put the keypad on the outside of the control panel.
Use M3 screws (6 mm (0.2 in) depth cross-recessed pan head screws) to attach the keypad from the inside.
Tighten the screws to a tightening torque of 0.49 N∙m to 0.73 N∙m (4.34 in∙lb to 6.46 in∙lb).
To Next Page
Loading...
