Electrical Installation
3
3.8 Connect the Bypass to a PC
YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference 109
3.8 Connect the Bypass to a PC
The bypass control board has a mini-B type USB port.
You can use a USB cable (USB 2.0, type: A - mini-B) to connect the bypass to a type-A USB port on a PC. Remove
the keypad to connect the USB cable to the port on the bypass control board. After you connect the drive to the PC,
you can use Yaskawa DriveWizard HVAC software to monitor drive performance and manage parameter settings.
Visit the Yaskawa website to download the DriveWizard HVAC software:
https://www.yaskawa.com/products/drives/hvac-drives/software-tools/drivewizard-hvac
A - Mini-B type connector
B - USB 2.0, type A - mini-B cable
C - Type-A connector
D - PC
Figure 3.24 Connect to a PC (USB)
Yaskawa recommends that you use a USB cable with connectors connected with shielded wires.
Figure 3.25 Recommended USB Cable
To Next Page
Loading...
