YASKAWA HV600

6.3 Faults, Minor Faults, Alarms, and Error Codes Listed Alphabetically
464 YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
Display (Hex.) Name ALM LED Type Ref.
oH3 (0022) Motor Overheat (PTC Input) Flashing Alarm 505
oH4 (0020) Motor Overheat Fault (PTC Input) Illuminated Drive Fault 489
oL1 (000B) Motor Overload Illuminated Drive Fault 489
oL2 (000C) Drive Overload Illuminated Drive Fault 490
oL3 (0005) Overtorque 1 Flashing Alarm 506
oL3 (000D) Overtorque Detection 1 Illuminated Drive Fault 491
oL4 (0006) Overtorque 2 Flashing Alarm 506
oL4 (000E) Overtorque Detection 2 Illuminated Drive Fault 491
oL7 (002B) High Slip Braking Overload Illuminated Drive Fault 491
oPE01 Drive Capacity Setting Fault Flashing Parameter Setting Error 509
oPE02 Parameter Range Setting Error Flashing Parameter Setting Error 509
oPE03 Multi-Function Input Setting Err Flashing Parameter Setting Error 509
oPE05 Run Cmd/Freq Ref Source Sel Err Flashing Parameter Setting Error 510
oPE07 Analog Input Selection Error Flashing Parameter Setting Error 510
oPE08 Parameter Selection Error Flashing Parameter Setting Error 510
oPE09 PID Control Selection Fault Flashing Parameter Setting Error 510
oPE10 V/f Data Setting Error Flashing Parameter Setting Error 511
oPE11 Carrier Frequency Setting Error Flashing Parameter Setting Error 511
oPE16 Energy Saving Constants Error Flashing Parameter Setting Error 511
oPE29 Baud Rate Setting Error Flashing Parameter Setting Error 511
oPE33 Digital Output Selection Error Flashing Parameter Setting Error 511
oPE34 HAND/OFF/AUTO Input Setting Flashing Parameter Setting Error 512
oPE36 Bypass Energy Savings Setting Err Flashing Parameter Setting Error 512
oPr (001E) Keypad Connection Fault Illuminated Drive Fault 491
ov (0002) DC Bus Overvoltage Flashing Alarm 506
ov (0008) Overvoltage Illuminated Drive Fault 492
ov2 (0405) DC Bus Overvoltage 2 Illuminated Drive Fault 492
ovEr Too Many Parameters Changed - Not an alarm. 506
OV_PRESS (00CD) Over Pressure Detected Flashing Alarm 506
PASS Modbus Communication Test Flashing Not an alarm. 506
PE1 (0047)
PE2 (0048)
PLC Faults Illuminated Drive Fault 492
PF (0047) Input Phase Loss Flashing Alarm 506
PF (001B) Input Phase Loss Illuminated Drive Fault 492
rdEr Error Reading Data - Backup Function Runtime Error 516
SAFE (0062) Customer Safeties Flashing Alarm 507
SAFE (00C9) Safety Open Flashing Alarm 507
SC (0005) Short Circuit/IGBT Failure Illuminated Drive Fault 493
SCF (040F) Safety Circuit Fault Illuminated Drive Fault 493
SE (0020) Modbus Test Mode Error Flashing Alarm 507
SEr (003B) Speed Search Retries Exceeded Illuminated Drive Fault 493
SMK_ALRM (00CC) Smoke Alarm Active Flashing Alarm 507
STo (003C) Safe Torque OFF - Alarm 507