7 Debugging
7.3 Debugging via Telnet Communication
7-5
HW1484528
HW1484528
(3) Select {SYSTEM} under the main menu, then select {SETUP}. In
the setup window, select {OPTION} to open {NETWORK}. In the
NETWORK window, select “DETAIL” for “HOST SETUP”.
(4) Setup the IP address in HOST SETUP window.
Nomal setting for the IP address is 192.168.255.1.
Ensure the PC IP address is on the same subnet as the
YRC1000micro.
In the case of the setting for the following YRC1000micro, the set-
ting for PC is as follows. IP adrress:192.168.255.xx (xx: 0-255,
decimal number, different from YRC1000micro value),
Subnet mask: 255.255.255.0
2. Restrictions on the IP address setting:
The Ethernet function on the YRC1000micro does not support
“10.0.0.xx” in the local IP address (xx: 0-255, decimal number). Thus,
DO NOT use “10.0.0.xx” for the IP address.
To Next Page
Loading...
