Yealink T46G - Page 125

Configuring Basic Features
111
Parameters
Permitted Values
Default
Day: 1=the first day in a month,…, 31= the last day in a month
Hour: 0=0am, 1=1am,…, 23=11pm
If “local_time.dst_time_type” is set to 1 (DST By Week), use the mapping:
Month: 1=January, 2=February,…, 12=December
Day of Week Last in Month: 1=the first week in a month,…, 5=the last week in a month
Day of Week: 1=Monday, 2=Tuesday,…, 7=Sunday
Hour of Day: 0=0am, 1=1am,…, 23=11pm
Note: It works only if the value of the parameter “local_time.summer_time” is set to 1
(Enabled).
Web User Interface:
Settings->Time & Date->End Date
Phone User Interface:
None
local_time.offset_time
Integer from -300 to 300
Blank
Description:
Configures the offset time (in minutes) of DST.
Note: It works only if the value of the parameter “local_time.summer_time” is set to 1
(Enabled).
Web User Interface:
Settings->Time & Date->Offset(minutes)
Phone User Interface:
None
To configure the DST via web user interface:
1. Click on Settings->Time & Date.
2. Select Disabled from the pull-down list of Manual Time.
3. Select the desired time zone from the pull-down list of Time Zone.
4. Enter the domain name or IP address in the Primary Server and Secondary Server field
respectively.
5. Enter the desired time interval in the Synchronism (15~86400s) field.
6. Mark the Enabled radio box in the Daylight Saving Time field.
- Mark the DST by Date radio box in the Fixed Type field.
Enter the start time in the Start Date field.