Yealink T46G

Getting Started
45
3. Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS fields.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click OK to reboot the Skype for Business phone.
To configure the IP mode via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->WAN Port.
2. Press or , or the Switch soft key to select IPv4, IPv6 or IPv4 & IPv6 from the IP
Mode field.
3. Press the Save soft key to accept the change.
The Skype for Business phone reboots automatically to make settings effective after a
period of time.
To configure a static IPv4 address via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Press or , or the Switch soft key to select the Static IP from the Type field.
3. Enter the desired value in the IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS field respectively.
4. Press the Save soft key to accept the change.
The Skype for Business phone reboots automatically to make settings effective after a
period of time.
PPPoE
PPPoE (Point-to-Point Protocol over Ethernet) is a network protocol used by Internet Service
Providers (ISPs) to provide Digital Subscriber Line (DSL) high speed Internet services. PPPoE
allows an office or building-full of users to share a common DSL connection to the Internet.
PPPoE connection is supported by the Skype for Business phone Internet port. Contact your ISP
for the PPPoE user name and password. PPPoE is not applicable to T42G/T41P/T40P Skype for