Yealink T46G

Configuring Basic Features
213
Parameters
Permitted Values
Default
Note: It works only if the value of the parameter “sip.btoe.enable” is set to 1 (Enabled).
Web User Interface:
Settings->BToE->BToE paring Mode
Phone User Interface:
Menu->Features->BToE->BToE Pairing Mode
To configure BToE feature via web user interface:
1. Click on Settings->BToE.
2. Select the desired value from the pull-down list of BToE.
3. Select the desired generation from the pull-down list of BToE Pairing Mode.
4. Click Confirm to accept the change.
To configure BToE feature via phone user interface:
1. Press Menu-> Features->BToE.
2. Press or , or the Switch soft key to select Enabled from the BToE field.