Yealink T46G

Getting Started
27
Parameters
Permitted Values
Default
0-DHCP
1-PPPoE (not applicable to T42G/T41P/T40P Skype for Business phones)
2-Static IP Address
Note: It works only if the value of the parameter “network.ip_address_mode” is set to 0
(IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the Skype for Business phone will
reboot to make the change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->WAN Port->IPv4
To configure DHCP via web user interface:
1. Click on Network->Basic.
2. In the IPv4 Config block, mark the DHCP radio box.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
4. Click OK to reboot the Skype for Business phone.
To configure DHCP via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Press or , or the Switch soft key to select DHCP from the Type field.
3. Press the Save soft key to accept the change.
The Skype for Business phone reboots automatically to make settings effective after a
period of time.