Yealink T46G

Getting Started
41
Parameters:
network.internet_port.type
network.ip_address_mode
network.internet_port.ip
network.internet_port.mask
network.internet_port.gateway
network.primary_dns
network.secondary_dns
Local
Web User Interface
Configure network parameters of
the Skype for Business phone
manually.
Navigate to:
http://<phoneIPAddress>/servlet?p
=network&q=load
Phone User Interface
Configure network parameters of
the Skype for Business phone
manually.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.internet_port.type
0, 1 or 2
0
Description:
Configures the Internet (WAN) port type for IPv4.
0-DHCP
1-PPPoE (not applicable to T42G/T41P/T40P Skype for Business phones)
2-Static IP Address
Note: It works only if the value of the parameter “network.ip_address_mode” is set to 0
(IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the Skype for Business phone will
reboot to make the change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Advanced (default password: admin)->Network->WAN Port->IPv4
network.ip_address_mode
0, 1 or 2
0
Description:
Configures the IP address mode.