YOKOGAWA EML500 Series User Manual

vi
IM80B80T10E 21th Edition : Jul.1,2007-00
WARNING
Electrical shock
· To avoid electrical shock, turn off the power before making wiring connections.
 Removal of Measurement Rod
· To remove the measurement rod, Pull it all the way up and close the seawater valve.
Then remove the rod.
· If the rod is removed before closing the valve, seawater will spew out through the valve.
· To remove the chain, fully close the valve (for the HS,HV, and FA models).
Then remove the chain.
CAUTION
 Do not use a megger for inspection purposes except for on-board power supply terminals.
Otherwise, the equipment may be damaged.
 Do not use a megger for sensor inspections. Otherwise, the sensor may be damaged.
 Do not drop the measurement rod or allow any mechanical shock at the tip of the rod. Other-
wise, the rod may be damaged.

YOKOGAWA EML500 Series Specifications

General

Brand	YOKOGAWA
Model	EML500 Series
Category	Measuring Instruments
Language	English