IBM 468X / 469X Interface 9 - 3
IBM Parameter Defaults
Table 9-1 lists defaults for IBM host parameters. Change these values in one of two ways:
• Scan the appropriate bar codes in this chapter. The new value replaces the standard default value in
memory. To recall default parameter values, see Default Parameters on page 4-5.
• Configure the scanner using the 123Scan
2
configuration program. See Chapter 12, 123Scan and Software
Tools.
NOTE See Appendix A, Standard Default Parameters for all user preference, host, symbology, and
miscellaneous default parameters.
Table 9-1 IBM 468X/469X Interface Parameter Defaults
Parameter Default
Page
Number
IBM 468X/469X Host Parameters
Port Address None
9-4
Convert Unknown to Code 39 Disable
9-5
RS-485 Beep Directive Ignore
9-5
RS-485 Bar Code Configuration Directive Ignore
9-6
To Next Page
Loading...
