11 - 30 DS2208 Digital Scanner Product Reference Guide
Check ISBT Table
Parameter # 578
SSI # F1h 42h
The ISBT specification includes a table that lists several types of ISBT bar codes that are commonly used in pairs.
If you set ISBT Concatenation to Enable, enable Check ISBT Table to concatenate only those pairs found in this
table. Other types of ISBT codes are not concatenated.
ISBT Concatenation Redundancy
Parameter # 223
SSI # DFh
If ISBT Concatenation on page 11-29 is set to Autodiscriminate ISBT Concatenation (default), you can set the
number of times the scanner must decode an ISBT symbol before determining that there is no additional symbol.
To do so, scan ISBT Concatenation Redundancy below and then scan bar codes in Appendix G, Numeric Bar
Codes to set a value between 2 and 20. Enter a leading zero for single digit numbers. To correct an error or change
a selection, scan Cancel on page G-3. The default is 10.
*Enable Check ISBT Table
(1)
Disable Check ISBT Table
(0)
ISBT Concatenation Redundancy
To Next Page
Loading...
Need help?
General
Weight and Dimensions
