Zebra DS2208

APPENDIX A STANDARD DEFAULT
PARAMETERS
Table A-1 Parameter Defaults
Parameter
Parameter
Number
SSI Number Default
Page
Number
User Preferences
Set Default Parameter N/A 4-5
Parameter Bar Code Scanning 236 ECh Enable 4-6
Beep After Good Decode 56 38h Enable 4-6
Beeper Volume 140 8Ch High 4-7
Beeper Tone 145 91h Medium 4-8
Beeper Duration 628 F1h 74h Medium 4-9
Suppress Power Up Beeps 721 F1h D1h Do Not Suppress 4-9
LED on Good Decode 744 F1h E8h Enable 4-10
Direct Decode Indicator 859 F2h 5Bh Disable 4-11
Low Power Mode 128 80h Disable 4-12
Time Delay to Low Power Mode 146 92h 1 Hour 4-13
Trigger Mode (or Hand-Held Trigger
Mode)
138 8Ah Auto Aim 4-15
Hands-Free Mode 630 F1h 76h Enable 4-16
Hand-Held Decode Aiming Pattern 306 F0h 32h Enable 4-17
Hands-Free (Presentation) Decode
Aiming Pattern
590 F1h 4Eh Enable Hands-Free
(Presentation) Decode Aiming
Pattern on PDF
4-18
Picklist Mode 402 F0h 92h Disable Picklist Mode Always 4-19