Zebra DS2208

User Preferences & Miscellaneous Options 4 - 3
Trigger Mode (or Hand-Held Trigger Mode) 138 8Ah Auto Aim 4-15
Hands-Free Mode 630 F1h 76h Enable 4-16
Hand-Held Decode Aiming Pattern 306 F0h 32h Enable 4-17
Hands-Free (Presentation) Decode Aiming
Pattern
590 F1h 4Eh Enable Hands-Free
(Presentation) Decode
Aiming Pattern on PDF
4-18
Picklist Mode 402 F0h 92h Disable Picklist Mode
Always
4-19
Continuous Bar Code Read 649 F1h 89h Disable 4-20
Unique Bar Code Reporting 723 F1h D3h Enable 4-20
Decode Session Timeout 136 88h 9.9 Seconds 4-21
Hands-Free Decode Session Timeout 400 F0 90 15 4-21
Timeout Between Decodes, Same Symbol 137 89h 0.5 Seconds 4-22
Timeout Between Decodes, Different
Symbols
144 90h 0.1 Seconds 4-22
Decode Mirror Images (Data Matrix Only) 537 F1h 19h Auto 4-23
Mobile Phone/Display Mode N/A N/A N/A 4-23
PDF Prioritization 719 F1h CFh Disable 4-24
PDF Prioritization Timeout 720 F1h D0h 200 ms 4-24
Decoding Illumination 298 F0h 2Ah Enable 4-25
Illumination Brightness 669 F1h 9Dh High 4-25
Low Light Scene Detection 810 F2h 2Ah Dim Illumination Low
Light Assist Scene
Detection
4-26
Motion Tolerance (Hand-Held Trigger Mode
Only)
858 F2h 5Ah Less 4-27
Table 4-1 User Preferences Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.