ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 109 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
 Software side
Login to ZKBio Access software, click System > Communication >
Communication Monitor to set the ADMS service port, as shown in the figure
below:
Add Device on the Software 16.2
Add the device by searching. The process is as follows:
1. Click Access Control > Device > Search Device, to open the Search
interface in the software.
2. Click Search, and it will prompt [Searching……].
3. After searching, the list and total number of access controllers will be
displayed.

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g