ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 16 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
 Do not wear hats, masks, sunglasses or eyeglasses.
 Be careful not to display two faces on the screen. Register one person
at a time.
 It is recommended for a user wearing glasses to register both faces
with and without glasses.
 Recommendation for authenticating a face
 Ensure that the face appears inside the guideline displayed on the
screen of the device.
 Sometimes, authentication may fail due to the change in the wearing
glasses then the one used while registration. In such a case, you may
require authenticating your face with the previously worn glasses. If
your face was registered without glasses, you should authenticate
your face without glasses further.
 If a part of the face is covered with a hat, a mask, an eye patch, or
sunglasses, authentication may fail. Do not cover the face, allow the
device to recognize both the eyebrows and the face.
Standby Interface 4.4
After connecting the power supply, the following standby interface is
displayed:

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g