ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 94 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Reset Access Setting
The access control reset parameters include door
lock delay, door sensor delay, door sensor type,
verification mode, door available time period,
normal open time period, master device, and
alarm. However, erased access control data in
Data Mgt. is excluded.
Time Schedule 12.2
Tap Time Rule Setting on the Access Control interface to configure the time
settings.
 The entire system can define up to 50 Time Periods.
 Each time-period represents 10 Time Zones, i.e., 1 week and 3 holidays,
and each time zone is a standard 24 hour period per day and the user can
only verify within the valid time-period.
 One can set a maximum of 3 time periods for every time zone. The
relationship among these time-periods is "OR". Thus, when the
verification time falls in any one of these time-periods, the verification is
valid.
 The Time Zone format of each time-period is HH MM-HH MM, which is
accurate to minutes according to the 24-hour clock.
Tap the grey box to search the required Time Zone and specify the required
Time Zone number (maximum up to 50 zones).

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g