ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 90 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
12 Access Control
On the Main Menu, tap Access Control to set the schedule of the door
opening, locks control and to configure other parameters settings related to
access control.
To gain access, the registered user must meet the following conditions:
1. The relevant door’s current unlock time should be within any valid time
zone of the user’s time period.
2. The corresponding user’s group must be already set in the door unlock
combination (and if there are other groups, being set in the same access
combo, then the verification of those group’s members is also required to
unlock the door).
3. In default settings, new users are allocated into the first group with the
default group time zone, where the access combo is "1" and is set in
unlock state by default.

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g