ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 31 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Procedure to set for Combined Verification Mode
 Combined verification requires personnel to register all the different
verification methods. Otherwise, employees will not be able to
successfully verify the combined verification process.
 For instance, when an employee has registered only for the face data, but
the Device verification mode is set as “Face + Password”, the employee
will not be able to complete the verification process successfully.
 This is because the Device compares the face template of the person
with the registered verification template (both the Face and the
Password) previously stored to that Personnel ID in the Device.
 But as the employee has registered only the Face but not the Password,
the verification will not get completed and the Device displays
“Verification Failed”.

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g