ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 64 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
 Tap Date and Time Auto Sync to enable automatic time synchronization
based on the service address you enter.
 Tap Manual Date and Time to manually set the date and time and then
tap to Confirm and save.
 Tap Select Time Zone to manually select the time zone where the device
is located.
 Enable or disable this format by tapping 24-Hour Time. If enabled, then
select the Date Format to set the date.
 Tap Daylight Saving Time to enable or disable the function. If enabled,
tap Daylight Saving Mode to select a daylight-saving mode and then
tap Daylight Saving Setup to set the switch time.

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g