ZKTeco SpeedFace-V3L User Manual

SpeedFace-V3L User Manual
Page | 70 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Face Rotation Angle
It is the rotation angle tolerance of a face for
facial template registration and comparison.
If a face’s rotation angle exceeds the set value, it
will be filtered by the algorithm, i.e., ignored by
the terminal thus no registration and comparison
interface will be triggered.
Image Quality
It is the image quality for facial registration and
comparison. The higher the value, the clearer
image is required.
Minimum Face Size
It sets the minimum face size required for facial
registration and comparison.
If the minimum size of the captured image is
smaller than the set value, then it will be filtered
off and not recognized as a face.
This value can also be interpreted as the face
comparison distance. The farther the individual
is, the smaller the face, and the smaller number
of pixels of the face obtained by the algorithm.
Therefore, adjusting this parameter can adjust
the farthest comparison distance of faces. When
the value is 0, the face comparison distance is not
limited.
LED Light Trigger
Threshold
This value controls the turning on and off of the
LED light. The larger the value, the LED light will
turn on or off more frequently.

ZKTeco SpeedFace-V3L Specifications

General

Display type	LCD
Screen shape	Flat
Built-in display	Yes
Display diagonal	2.4 \
Display size (HxV)	240 x 320 mm
Internal memory	256 GB
Processor cores	2
Internal storage capacity	512 GB
Operating system installed	Linux
Type	Face recognition terminal
Access code reader	-
Authentication type	Biometric, Face recognition
Access chip/card reader	No
Face recognition distance	0.5 - 2 m
False Rejection Rate (FRR)	0.02 %
False Acceptance Rate (FAR)	0.01 %
International Protection (IP) code	IP65
Operating temperature (T-T)	-5 - 45 °C
Total megapixels	1 MP
RS-485 ports	1
Package weight	800 g

Weight and Dimensions

Depth	58.5 mm
Width	185 mm
Height	20 mm
Weight	300 g