SpeedFace-V3L User Manual
Page | 73 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
1:N Threshold Value
Under 1:N verification method, the verification
will only be successful when the similarity
between the acquired fingerprint data and the
fingerprint templates enrolled in the device is
greater than the set value.
FP Sensor Sensitivity
To set the sensibility of fingerprint acquisition. It
is recommended to use the default level
"Medium
". When the environment is dry,
resulting in slow fingerprint detection, you can
set the level to "High
" to raise the sensibility;
when the environment is humid, making it hard
to identify the fingerprint, you can set the level to
"Low".
1:1 Retry Times
In 1:1 Verification, users might forget the
registered fingerprint, or press the finger
improperly. To reduce the process of re-entering
user ID, retry is allowed.
Fingerprint Image
To set whether to display the fingerprint image
on the screen during fingerprint enrollment or
verification. Four choices are available:
Show for Enroll: to display the fingerprint image
on the screen only during enrollment.
Show for Match: to display the fingerprint image
on the screen only during verification.
Always Show:
to display the fingerprint image
on screen during enrollment and verification.
None: not to display the fingerprint image.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
