Laser cutting and engraving workow
137
NOTE: The information on the Z axis height is stored in the motherboard internal mem-
ory. That is guided by the fact that this value is not easy to change manually by the user
unlike the X and Y axes.
NOTE: Don't home the Z axis when the milling cutter is in
the spindle and when there is material on the CNC work-
table. This will damage the milling cutter and might disar-
range the Z axis motors.
Press the 'Home X' and
'Home Y' buttons. Watch
out for your cutter not
to hit the material on the
worktable.
Go back to 'MOVE' menu, Using provided arrow
buttons, move the spin-
dle to the LOCAL starting
position.
NOTE: In most cases the local starting position will be the material surface left, front
corner.
NOTE: Toggle the distance button for better control over the cutter.
To Next Page
Loading...
Need help?
General
