Zmorph VX - Page 50

3D printing workow
50
• Nozzles: 0.2, 0.3, 0.4 mm
• Motor: Nema 17 stepper motor
• Extrusion: Direct drive
• Work area: up to 235 x 250 x 165 mm
• Recommended printing resolution: 0.2 mm (200 microns)
• Supported printing resolution: 0.05 - 0.4 mm
• Extruder dimensions: 135 x 115 x 55 mm
Single Plastic Extruder 3.0 mm
Toolhead being sold separately on special request. It operates on 3 mm laments. De-
fault nozzle is 0.4 mm.
Cooling fan
Nozzle
Heating block
Thermistor
Heat break
"A" plug
Pressure adjustment screws
Stepper motor 1.75
Toolhead cable
Specication:
• Construction: High-quality 3 mm aluminium frame
• Hot End: ZMorph interchangeable nozzle 3.0 mm
• Temperature control: 1 thermistor
• Temperature range: 0 - 250 ˚C degrees
• Nozzle 0.3, 0.4 mm
• Motor: Nema 17 stepper motor with planetary gear