Zmorph VX - Page 57

3D printing workow
57
NOTE: Third menu named ALL maintain both laments at the same time. Tap down
arrow with ALL description to feed both laments.
NOTE: By tapping the button showing "80 mm" you can change the amount of extruded
lament to 15 mm or 5 mm.
Push the lament down
until you feel it has been
grabbed by the extruder
drive gear.
Insert the second la-
ment into the right side
guide hole on top of the
extruder.
Tap the bottom arrow on
the screen to feed 80 mm
of the lament. Choose
down arrow with RIGHT
description to do that.
Push the lament down
until you feel it has been
grabbed by the extruder
drive gear.
Wait until the material
ows out of the nozzle.
Tap the feed button
again if necessary.