Zmorph VX - Page 82

3D printing workow
82
c) Adaptive height - option to enable or disable the height of the Adaptive Layer. This
function allows the program to adjust the height of the print layer depending on the
geometry of the model. The path width and default layer height values change to
ranges that can be modied again using the Quality slider.
d) Durability - settings for the durability of the model. This function takes into account
the number of model outlines as well as the scope and type of the inll. There are
5 types:
• Adaptive - allows for inll optimization and faster print. Imposes 2 outlines and
40-80% inll.