Zte ZXR10 8900 Series - Configuring Queue Scheduling

ZXR108900SeriesUserManual(BasicCongurationVolume)
Step
CommandFunction
1
ZXR10(config)#nas
Thisentersnasconguration
mode
2
ZXR10(config-nas)#ratelimitThisentersratelimit
congurationmode
3
ZXR10(config-nas-ratelimit)#iphost<ip-addr>vlan
<vlan-id>{down-rate|up-rate}{k<64-1000>|m<10
-1000>}
Thislimitstherateofuplink
ordownlinkusers
4
ZXR10(config)#showratelimit{all|host-ip
<ip-addr>}
Thisviewsconguration
informationofLayer3rate
limit
ExampleThisexampleshowshowtocongureLayer3ratelimit.
ZXR10(config)#nas
ZXR10(config-nas)#ratelimit
ZXR10(config-nas-ratelimit)#iphost168.1.2.3vlan20down-ratek600
ZXR10(config-nas-ratelimit)#iphost168.1.2.4vlan20up-ratek300
ZXR10(config-nas-ratelimit)#exit
ZXR10(config-nas)#exit
ZXR10(config)#showratelimitall
Host-ipVlanUp-rateDown-rate
168.1.2.320-600K
168.1.2.420300K-
ConfiguringQueueScheduling
ZXR108900seriesswitchsupportsSPandWRRqueuescheduling
modes.Whenthesetwomodesaremixedused,SPhasahigher
priorityoverWRR.
Tocongurequeuescheduling,usethefollowingcommand.
CommandFunction
ZXR10(config-if)#queue-mode{strict-priority|{dwrr
<queue-no><dwrr-weight>&<1-8>}|{wrr<queue-no
><wrr-weight>&<1-8>}}
Thisconguresqueue
schedulinganddefault802.1p
priorityonport.
Note:
Valuerangeofdwrr-weightis1~160000.Valuerangeofwrr-weight
is1~15.
ExampleCongurestrictschedulingbasedonpriorityoninterfacegei_1/1.
EnableWRRschedulingoninterfacegei_1/2.WeightsofQueues
0~7are10,5,8,10,5,8,9,10respectively.Setthedefault
802.1pofinterfacegei_1/2to5.
ZXR10(config)#interfacegei_1/1
ZXR10(config-gei_1/1)#queue-modestrict-priority
ZXR10(config-gei_1/1)#exit
ZXR10(config)#interfacegei_1/2
98CondentialandProprietaryInformationofZTECORPORATION