ZyXEL Communications Ethernet Switch - Page 141

Chapter 33 IPv6 Commands
Ethernet Switch CLI Reference Guide
141
Multicast scope allows you to determine the size of the multicast group. A multicast address
has a predefined prefix of ff00::/8. The following table describes some of the predefined
multicast addresses.
The following table describes the multicast addresses which are reserved and can not be
assigned to a multicast group.
Loopback
A loopback address (0:0:0:0:0:0:0:1 or ::1) allows a host to send packets to itself. It is similar
to “127.0.0.1” in IPv4.
Table 84 Predefined Multicast Address
MULTICAST ADDRESS DESCRIPTION
FF01:0:0:0:0:0:0:1 All hosts on a local node.
FF01:0:0:0:0:0:0:2 All routers on a local node.
FF02:0:0:0:0:0:0:1 All hosts on a local connected link.
FF02:0:0:0:0:0:0:2 All routers on a local connected link.
FF05:0:0:0:0:0:0:2 All routers on a local site.
FF05:0:0:0:0:0:1:3 All DHCP severs on a local site.
Table 85 Reserved Multicast Address
MULTICAST ADDRESS
FF00:0:0:0:0:0:0:0
FF01:0:0:0:0:0:0:0
FF02:0:0:0:0:0:0:0
FF03:0:0:0:0:0:0:0
FF04:0:0:0:0:0:0:0
FF05:0:0:0:0:0:0:0
FF06:0:0:0:0:0:0:0
FF07:0:0:0:0:0:0:0
FF08:0:0:0:0:0:0:0
FF09:0:0:0:0:0:0:0
FF0A:0:0:0:0:0:0:0
FF0B:0:0:0:0:0:0:0
FF0C:0:0:0:0:0:0:0
FF0D:0:0:0:0:0:0:0
FF0E:0:0:0:0:0:0:0
FF0F:0:0:0:0:0:0:0