Ethernet Switch CLI Reference Guide
125
CHAPTER 29
Interface Commands
Use these commands to configure basic port settings.
29.1 Command Summary
The following section lists the commands for this feature.
Table 73 interface Command Summary
COMMAND DESCRIPTION M P
clear interface <port-num> Clears all statistics for the specified port. E 13
interface port-channel <port-list> Enters config-interface mode for the specified port(s). C 13
bpdu-control
<peer|tunnel|discard|network>
Sets how Bridge Protocol Data Units (BPDUs) are used
in STP port states.
peer: process any BPDU (Bridge Protocol Data Units)
received on this port.
tunnel: forward BPDUs received on this port.
discard: drop any BPDU received on this port.
network: process a BPDU with no VLAN tag and
forward a tagged BPDU.
C13
cx4-length <0.5|1|3|5|10|15> Sets the number of meters for the length of the
10GBASE-CX4 cable you use to connect between the
Switch and another switch for stacking.
C13
flow-control Enables interface flow control. Flow control regulates
transmissions to match the bandwidth of the receiving
port.
C13
frame-type
<all|tagged|untagged>
Choose to accept both tagged and untagged incoming
frames (all), just tagged incoming frames (tagged) or
just untagged incoming frames on a port (untagged).
Note: Not all switch models support accepting
untagged frames on a port.
C13
inactive Disables the specified port(s) on the Switch. C 13
intrusion-lock Enables intrusion lock on the port(s) and a port cannot be
connected again after you disconnected the cable.
Note: Intrusion lock is not available on a 10
Gigabit Ethernet port.
C13
name <port-name-string> Sets a name for the port(s).
port-name-string: up to 64 English keyboard
characters
C13
To Next Page
Loading...
Need help?
General
